E 250 V10-6.8L VIN S (2005)
Fuel Temperature Sensor: Service and Repair
FUEL RAIL PRESSURE AND TEMPERATURE SENSOR
Removal and Installation
1. Release the fuel system pressure.
2. Remove the engine cover.
3. Disconnect the battery ground cable.
4. Disconnect the fuel injection pressure and temperature sensor electrical connector and vacuum hose.
5. Remove the bolts and fuel injection pressure and temperature sensor.
6. NOTE: Hand tighten both bolts before tightening to specification.
To install, reverse the removal procedure.
-
Apply clean engine oil to the sensor O-ring seal prior to installing the fuel injection pressure and temperature sensor.
