E 250 V10-6.8L VIN S (2005)
Throttle Body: Service and Repair
THROTTLE BODY
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable mixtures are always present and can be ignited, resulting in possible personal injury.
1. Disconnect the battery ground cable.
2. Remove the engine cover.
3. Remove the engine air cleaner assembly and the air cleaner outlet tube.
4. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the electronic throttle body (TB) electrical connector.
5. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the throttle position (TP) sensor electrical connector.
6. Remove the four bolts and the TB.
-
Remove and discard the TB gasket.
Installation