E 250 V10-6.8L VIN S (2005)
10. Install the upper steering column shroud.
11. Install the ignition switch lock cylinder.
1
Turn the ignition switch lock cylinder to the RUN position.
2
Insert the ignition switch lock cylinder into the steering column housing.
3
Make sure the ignition switch lock cylinder is fully seated and aligned in the inter-locking washer before turning the key to the OFF position.
This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole in the steering column.
12. Rotate the ignition switch lock cylinder, using the key, to make sure of correct mechanical operation in all positions.
13. Install the lower steering column shroud.
14. Install the steering column opening cover.
15. If so equipped, install the tilt wheel handle and shank.
16. Install the steering wheel.
17. Connect the clockspring electrical connectors.
Install the pin-type retainers into the bracket.
18. Install the steering column opening lower finish panel reinforcement.
1. Position the steering column opening lower finish panel reinforcement.
2. Install the bolts.
3. Install the electrical connector pin-type retainers.
4. Position the data link connector and install the screws.
