E 250 V10-6.8L VIN S (2005)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Functional
IGNITION LOCK CYLINDER - FUNCTIONAL
Removal and Installation
NOTE: When a new lock cylinder is installed, the door lock cylinder and ignition lock cylinder should be installed as a set. This eliminates carrying and
extra key which will fit only one lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.
1. Disconnect the battery.
2. Remove the ignition switch lock cylinder.
1
Turn the ignition switch to the ON position.
2
Using a suitable tool, press the ignition switch lock cylinder release pin while pulling out the ignition switch lock cylinder.
3. To install, reverse the removal procedure.