E 250 V10-6.8L VIN S (2005)
4. Remove the tie rod end.
1. Loosen the nuts on the tie rod adjusting sleeve.
2. Count the number of turns while removing the tie rod end from the tie rod adjusting sleeve.
5. Remove the tie rod adjusting sleeve. Count the number of turns required to remove the tie rod adjusting sleeve clamp.
Installation
1. NOTE: The two bolts and nuts on the tie rod adjusting sleeve clamp for the tie rod end must be positioned within a limit of 45 degrees
(+/-). The threaded ends of the bolts on the left tie rod end point toward the front of the vehicle. The threaded ends on the right tie rod
end face rearward.
Follow the removal procedure in reverse order. Make sure the adjuster clamps are in the correct position.
2. Tighten the tie rod adjusting sleeve.
3. Install the ball stud in the front wheel spindle, then tighten the castle nut.
4. Install a new cotter pin.
5. Check toe-in.
6. Check clear vision.
