E 250 V10-6.8L VIN S (2005)
4. Using the special tool, disconnect the tie-rod end.
5. Remove and discard the cotter pin and the nut.
6. Remove the caster/camber insert pinch bolt.
7. CAUTION: To prevent damage to the ball joint seal and the ball joint socket, do not use a pickle fork-type remover to loosen the ball joints.
Remove the front wheel spindle.
1. Strike the lower end of the front axle to loosen the ball joint.
2. Remove the front wheel spindle.
8. To install, reverse the removal procedure.
^
Check and, if necessary, align the front end.
