E 250 V10-6.8L VIN S (2005)
1. Install the inlet and outlet lines from auxiliary fluid cooler and radiator in-tank reservoir.
1. Install the cooler line clips.
2. Connect the fluid lines to the radiator in-tank reservoir.
3. Connect the hose and install the constant tension clamp from the auxiliary cooler outlet.
4. Connect the hose and install the constant tension clamp from the fluid filter return inlet line.
2. Install the remote mount transmission fluid filter bracket.
3. Install the fluid cooler tubes, the fluid cooler tube bracket and the fluid cooler tube bracket nut.
4. Connect the transmission cooler inlet and outlet lines to the remote mount fluid filter housing.
5. Install the fluid cooler tubes in the front and rear cooler line case fittings.
^
Tighten to 40 Nm (30 ft.lbs.).
