E 250 V10-6.8L VIN S (2005)
All vehicles
6. Connect the output shaft speed (OSS) sensor.
7. Install the rear transmission support insulator.
1. Install the rear transmission support insulator.
2. Lower the transmission onto the transmission support insulator.
8. Install the transmission insulator bolts and nuts.
9. Install the driveshaft.
10. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
11. With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the
transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is
achieved (fluid should be in the cross-hatched area of the fluid level indicator).
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
