E 250 V10-6.8L VIN S (2005)
7. Connect the molded lead frame to the solenoids.
^
Connect the bulkhead interconnector by pressing it in place by hand and fully seating the connector in place.
^
Connect the EPC solenoid by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully
through the connector slots.
^
Connect the TCC by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the
connector slots.
^
Connect the shift solenoid SSA and SSB by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals
pass fully through the connector slots.
8. NOTE: If the transmission is being repaired for a contamination related failure, use a new fluid filter and seal assembly. The fluid filter can be
reused if no excessive contamination is present.
Install a new fluid filter and seal.
9. Position the pan magnet into the transmission fluid pan.
