E 250 V10-6.8L VIN S (2005)
Wiring Harness: Service and Repair
Internal Harness Service
Removal
1. Remove the main control solenoid body.
2. Disconnect the internal wiring harness.
1. Remove the two screws.
2. Disconnect the transmission fluid temperature sensor electrical connector.
3. Disconnect the solenoid electrical connectors.
3. Remove the bulkhead connector O-ring.
4. Lift the tab twisting the bulkhead connector, and push it through the solenoid body, and remove the wire harness.
Installation
1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
