E 250 V10-6.8L VIN S (2005)
2. Index-mark the driveshaft flange and the pinion flange to maintain driveline balance during assembly.
3. Remove the four bolts.
4. CAUTION: The driveshaft flange fits tightly on the pinion flange pilot. Never hammer on the driveshaft or any of its components to disconnect
the driveshaft flange from the pinion flange. Pry only in the area shown, with a suitable tool, to disconnect the driveshaft flange from the pinion
flange.
Using a suitable tool as shown, disconnect the driveshaft flange yoke from the pinion flange and position the driveshaft aside.
5. CAUTION: Index-mark the pinion flange to the pinion shaft prior to removal.
Use the special tool to prevent the flange from turning while removing the lock nut and washer.
