E 250 V10-6.8L VIN S (2005)
6. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
7. Install the driveshaft slip-yoke on the coupling shaft.
1
Pull the slip-yoke boot toward the coupling shaft. Lubricate the coupling shaft splines with approximately 10 grams (0.24 oz) of lubricant.
2
Position the slip-yoke boot clamp.
3
Align the blind splines, and install the driveshaft slip-yoke on the coupling shaft.
8. Set the driveshaft assembled length to specification.
1
Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2
Position the slip-yoke boot over the slip-yoke boot groove.
3
Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
4
Bleed the air from the slip-yoke boot.
9. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.
10. Install the driveshaft.
