E 250 V10-6.8L VIN S (2005)
1. Connect the front driveshaft to the transmission. Install the new bolts.
-
Hand-tighten only; do not tighten at this time.
2. Position the center support bearing and install the bolts.
-
Hand-tighten only; do not tighten at this time.
3. Tighten the driveshaft to transmission flange bolts and the driveshaft center bearing bolts.
4. Position the rear driveshaft assembly and install the center support bearing bolts.
-
Hand-tighten only; do not tighten at this time.