E 250 V8-4.6L (2007)
Separate the electrical connector pin-type retainers from the riser and remove the power seat wire harness.
All seats
9. NOTE: Note the connector locations and wire harness routing for installation.
NOTE: LH shown, RH similar.
Detach the safety belt buckle and pretensioner electrical connector from the seat riser.
10. Separate the riser from the seat track.
11. Remove the safety belt buckle and pretensioner.
1. Remove the bolt.
To install, tighten to 40 Nm (30 lb-ft).
2. Separate the safety belt buckle and pretensioner from the seat track.
3. Route out the wire harness and remove the safety belt buckle and pretensioner.
12. To install, reverse the removal procedure.