E 250 V8-4.6L (2007)
7. NOTE: Plug each port of the HCU to prevent brake fluid from spilling.
Disconnect the 2 brake tube fittings from the HCU.
^
To install, tighten to 17 Nm (13 ft. lbs).
8. Disconnect the anti-lock brake system (ABS) module electrical connector.
9. Remove the HCU bracket-to-inner fender well nuts and remove the HCU assembly.
^
To install, tighten to 29 Nm (21 ft. lbs.)
10. Remove the screws and the separate the ABS module from the HCU.
^
To install, tighten to 5 Nm (44 inch lbs).
11. To install, reverse the removal procedure.
^
Bleed the HCU after installation.
