E 250 V8-4.6L (2007)
4.6L (2V) engine
11. Using a new crankshaft pulley bolt, install the crankshaft pulley bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the
bolt in 4 stages:
^
Stage 1: Tighten to 120 Nm (89 ft. lbs).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs).
^
Stage 4: Tighten an additional 90 degrees without exceeding 200 Nm (148 ft. lbs).
5.4L (2V) engine
12. Using a new crankshaft pulley bolt, install the crankshaft pulley bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the
bolt in 4 stages:
^
Stage 1: Tighten to 90 Nm (66 ft. lbs).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs).
^
Stage 4: Tighten an additional 90 degrees.
All engines
13. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the CMP sensor and bolt.
^
Tighten to 10 Nm (89 inch lbs).
