E 250 V8-4.6L (2007)
8. Install the manual control lever.
1
Position the manual control lever.
2
Install a new manual control lever outer nut.
^
Tighten to 33 Nm (24 ft. lbs.)
9. Connect the selector lever cable end to the manual lever with the lever in the NEUTRAL position.
10. Install the digital TR sensor electrical connector.
11. Position the pan magnet into the transmission fluid pan.
12. NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage. If not damaged, the gasket should be reused.
Install the transmission fluid pan and gasket.
1
Position the transmission fluid pan gasket.
2
Position the transmission fluid pan.
