E 250 V8-4.6L (2007)
10. Connect the transmission-mounted parking brake linkage.
1
Compress the spring on the actuating cable and install the cable into the cable housing.
2
Install the actuating cable end onto the actuating lever and install the pin.
3
Install the hair pin retaining clip into the pin.
4
Connect the return spring to the pin.
11. Install the driveshaft.
12. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
13. With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust
the transmission fluid level and check for any leaks.
If fluid is needed, add fluid in increments of 0.24 L (0.5 pt) until the correct level is achieved (fluid should be in the hot range cross-hatched area
of the fluid level indicator).
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tool(s)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the shift cable end.