E 250 V8-4.6L (2007)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Rear, Two-Piece
Driveshaft - Rear Two-Piece
Material
Removal
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Index-mark the driveshaft to the rear axle pinion flange.
3. Remove 4 bolts and disconnect the rear driveshaft section.
4. Support the coupling shaft, and remove the 2 center bearing bracket bolts.
E-450 vehicles
5. Lock the parking brake.