E 250 V8-4.6L SOHC VIN W (2004)
Canister Purge Control Valve: Service and Repair
EVAPORATIVE EMISSION CANISTER PURGE VALVE
REMOVAL
1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it
still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an
electrical spark occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel is present in the area. Failure to follow these
instructions may result in personal injury.
Disconnect the battery ground cable.
2. Remove the engine cover.
3. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector and the vacuum hose.
4. Disconnect the EVAP hoses and remove the nuts and the EVAP canister purge valve.
INSTALLATION
1. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative
Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle
