E 250 V8-4.6L SOHC VIN W (2004)
Material
Removal
1. Raise and support the vehicle.
2. Remove the driveshaft.
3. Using the special tools, remove the extension housing seal.
4. CAUTION: Do not damage any machined surfaces. The new seal may leak.
Using the special tool, remove the extension housing bushing.
Installation
1. CAUTION: Prior to installing the extension housing bushing, inspect the extension housing counterbore for burrs. If necessary, remove the burrs
with an oil stone. Damage to new bushing may occur.
NOTE: The extension housing bushing is model dependent.
Align the extension housing bushing in the extension housing so that the slots are in the 2 o'clock and 7 o'clock positions.