E 250 V8-4.6L SOHC VIN W (2004)
15. Measure the differential case runout without the ring gear.
^
Check the case runout again with the new differential bearings. If the runout is within specification, use the new differential bearings for
assembly. If the runout is still excessive, a new differential case must be installed.
Installation
All vehicles
1. CAUTION: Make sure that the notches on the case flange and the anti-lock speed sensor ring are aligned.
Press the ring gear and, if removed, a new anti-lock speed sensor on the differential case.
2. Install the bolts.
^
Apply sealer to the ring gear bolts.
3. With pinion depth set and the pinion installed, place the differential case in the rear axle housing.
