E 250 V8-4.6L VIN W (2006)
Trim Panel: Service and Repair
A-Pillar Trim Panel
A-PILLAR TRIM PANEL
Removal and Installation
NOTE: Right side shown, left side similar.
1. Remove the right front assist handle covers.
2. Remove the assist handle.
-
Remove the 2 assist handle bolts and remove the assist handle.
-
To install, tighten to 12 Nm (9 lb-ft).
3. NOTE: To release upper retaining clip, pull down at the top of the A-pillar trim panel.
Pull the A-pillar trim panel downward to release the remaining clips.
4. To install, reverse the removal procedure.