E 250 V8-4.6L VIN W (2006)
2. Use a suitable suction device to remove the brake fluid from the brake master cylinder reservoir.
3. Disconnect the speed control deactivator switch electrical connector.
4. Disconnect the brake fluid level switch electrical connector.
5. Disconnect the master cylinder tube fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
^
For vehicles with traction control and stability assist, tighten to 28 Nm (21 ft. lbs.).
6. NOTE: Discard the brake master cylinder nuts. They are a torque-prevailing type and cannot be reused.
Remove the brake master cylinder nuts.
^
To install, tighten to 23 Nm (17 ft. lbs.).
^
For vehicles with traction control stability assist, tighten to 15 Nm (11 ft. lbs.).
7. Remove the brake master cylinder.
8. To install, reverse the removal procedure.
^
Bleed the brake system.
