E 250 V8-4.6L VIN W (2006)
Wheel Speed Sensor: Service and Repair
Rear
Anti-Lock Control
Rear Wheel Speed Sensor
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the rear wheel speed sensor electrical connector.
3. NOTE: Clean off dirt and foreign material that may have collected around the rear wheel speed sensor before removal.
Remove the rear wheel speed sensor bolt and the sensor.
^
To install, tighten to 27 Nm (20 ft. lbs.).
4. To install, reverse the removal procedure.
^
Inspect the wheel speed sensor O-ring for damage. Lightly lubricate the O-ring with rear axle lubricant.
^
Thoroughly clean the mounting surface.
Anti-Lock Control - Traction Control and Stability Assist
