E 250 V8-4.6L VIN W (2006)
Coolant Reservoir: Service and Repair
Degas Bottle
Removal and Installation
1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding.
2. NOTE: Gas engines will only have one coolant hose.
Disconnect the coolant hoses at the degas bottle.
3. Remove the bolts and position out the degas bottle.
^
To install, tighten to 6 Nm (53 inch lbs.).
4. Disconnect the engine fill tube and remove the degas bottle.
5. To install, reverse the removal procedure.
