E 250 V8-4.6L VIN W (2006)
4. CAUTION: This bolt is torque-to-yield and cannot be reused.
Using the special tool, remove the crankshaft pulley bolt and washer.
^
Discard the crankshaft pulley bolt.
5. Using the special tool, remove the crankshaft pulley.
Installation
1. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface
prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow
this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
2. Lubricate the crankshaft pulley sealing area with clean engine oil prior to installation.