E 250 V8-4.6L VIN W (2006)
2. Remove the A/C clutch disc and hub nut.
1
Using the special tool, hold the A/C clutch disc and hub.
2
Remove the A/C clutch disc and hub nut.
3. Remove the A/C compressor pulley snap ring.
4. CAUTION: Do not use air tools. Damage to the A/C clutch pulley or A/C compressor may result.
Using the special tool, remove the A/C clutch pulley.
5. Remove the A/C clutch field coil snap ring.
6. Remove the A/C clutch field coil.
Installation
NOTE: The A/C clutch components should be reused unless obvious signs of damage are found. If excessive grooving is found, a new A/C clutch disc
and hub and a new A/C compressor pulley must be installed together. Otherwise, each component can be installed individually where needed.
1. Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
-
Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
-
Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
-
Inspect for roughness in the A/C compressor pulley bearing.
2. Clean the A/C clutch field coil and pulley mounting surfaces.
3. Install the A/C clutch field coil.
4. NOTE: The A/C compressor pulley is a tight fit on the A/C compressor. It must be correctly aligned during installation.