E 250 V8-4.6L VIN W (2006)
Fuel Pressure Sensor/Switch: Service and Repair
FUEL RAIL PRESSURE AND TEMPERATURE SENSOR
Removal and Installation
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the
fuel tubes or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions can result in personal
injury.
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Remove the air cleaner and air cleaner outlet pipe.
4. Disconnect the fuel rail pressure and temperature sensor electrical connector and vacuum hose.
5. Remove the bolts and fuel rail pressure and temperature sensor.
-
Hand tighten both bolts before tightening to specification.
-
To install, tighten to 6 Nm (53 lb-in).
