E 250 V8-4.6L VIN W (2006)
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the
diagnostic procedure again.
1. Depower the SRS. For additional information, See: Air Bag(s) Arming and Disarming/Service and Repair
2. Remove the 2 driver air bag module bolt caps (1 shown) from the steering wheel.
3. Remove the 2 driver air bag module bolts (1 shown).
To install, tighten to 6 Nm (53 lb-in).
4. Disconnect the horn electrical connector.
5. CAUTION: The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag module.
Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag
module. Damage to the connector or component may occur.
Disconnect the driver air bag module electrical connector and remove the driver air bag module.
6. To install, reverse the removal procedure.
7. Repower the SRS. For additional information, See: Air Bag(s) Arming and Disarming/Service and Repair
