E 250 V8-4.6L VIN W (2006)
5. NOTE: Make sure to install the power steering pump pulley until it is flush with the power steering pump shaft. Inspect the belt alignment
following installation to make sure of correct alignment and prevent intermittent belt noise.
Using the special tool, remove the pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is no paint mark, use a
paint pencil to mark the web area of the pulley near the hub.
Installation
All vehicles
1. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed 2 times.
Using the special tool, install the pulley to the power steering pump.
2. If equipped, install the deflector shield.
3. Rotate the tensioner clockwise and install the accessory drive belt to the power steering pump pulley.
Vehicles with (6.0L). engine
4. Install the engine cooling fan.
