E 250 V8-4.6L VIN W (2006)
Removal and Installation
NOTE: New O-ring seals must be installed any time the lines are disconnected from the steering gear.
1. Place the front wheels in the straight-ahead position and the ignition switch in the OFF position.
2. CAUTION: Do not allow the steering column shaft to rotate while the intermediate shaft is disconnected or damage to the clockspring can result.
If there is evidence that the shaft has rotated, the clockspring must be removed and recentered.
Remove the bolt and detach the intermediate shaft from the gear.
^
To install, tighten to 25 Nm (18 ft. lbs.).
3. Disconnect the power steering line fittings from the steering gear.
^
Remove and discard the O-ring seals.
^
To install, tighten to 20 Nm (15 ft. lbs.).
