E 250 V8-4.6L VIN W (2006)
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align the index marks and position the driveshaft on the transmission.
^
Position the driveshaft to the rear differential.
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the 4 driveshaft bolts.
^
Tighten to 103 Nm (76 ft. lbs.).
Extension Housing Gasket
Extension Housing Gasket
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The output shaft and driveshaft are a balanced assembly.
Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.