E 250 V8-4.6L VIN W (2006)
1
Connect the park rod to the detent lever assembly.
2
Install the transmission range sensor and the detent lever assembly.
3
Loosely install the bolts.
2. Install the manual control lever shaft.
3. NOTE: Leave a small portion of the pin exposed.
Install the manual valve detent lever shaft retaining pin into the case.
4. NOTE: When the retaining pin is installed correctly, 2 mm (0.08 inch) of the pin will be exposed.
Install a new manual valve detent lever shaft retaining pin.
5. Tighten the bolts to 10 Nm (89 inch lbs.).