E 250 V8-4.6L VIN W (2006)
Transmission Cooler: Service and Repair
Transmission Cooling
Auxiliary Transmission Fluid Cooler
Material
Auxiliary Transmission Fluid Cooler
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If not done previously, carry out the transmission fluid cooler flow test procedure.
3. Remove the radiator grille opening panel reinforcement.
4. Disconnect the fluid cooler hoses from the auxiliary transmission fluid cooler.
5. Remove the 3 bolts and the auxiliary transmission fluid cooler.
Installation
1. Install the auxiliary transmission fluid cooler and the 3 bolts.
^
Tighten to 8 Nm (71 inch lbs.).
2. Connect the fluid cooler hoses to the auxiliary transmission fluid cooler. Install the hose clamps.
3. Install the radiator grille opening panel reinforcement.
4. Fill the transmission with the specified type and quantity of clean transmission fluid.