E 250 V8-4.6L VIN W (2006)
Windshield Washer Pump: Service and Repair
WINDSHIELD WASHER PUMP AND RESERVOIR
Removal and Installation
CAUTION: Do not make electrical connection prior to filling the windshield washer reservoir. Do not operate the windshield washer pump
prior to filling the windshield washer reservoir.
1. Raise and support the hood.
2. Remove the battery.
3. Remove the battery tray.
1
Remove the 4 bolts.
-
To install, tighten to 28 Nm (21 lb-ft).
2
Remove the battery tray.
4. NOTE: Windshield washer fluid must be collected in a container after the windshield washer hose is disconnected.
Remove the washer pump and reservoir.
1
Remove the nut.
-
To install, tighten to 4 Nm (35 lb-in).
2
Remove the bolt.
-
To install, tighten to 4 Nm (35 lb-in).
