E 250 V8-5.4L (2008)
Removal and Installation
1. Remove the upper door trim panel.
-
Pull outward on the upper door trim panel to release the 6 upper door trim panel retaining clips.
2. Remove the door pull handle.
-
Remove the 2 door pull handle screw covers.
-
Remove the 2 door pull handle screws.
3. Remove the lower door trim panel screw.
4. CAUTION: Do not pull directly outward on the lower door trim panel, as damage will occur.
Remove the lower door trim panel.
-
Lift the lower door trim panel upward and then outward.
-
If equipped, disconnect the electrical connector.
5. To install, reverse the removal procedure.