E 250 V8-5.4L (2008)
5. Remove the cushion inboard side shield front screw.
6. Remove the cushion inboard side shield.
1. Pull the cushion inboard side shield away from the seat to clear the safety belt buckle and pretensioner.
2. Rotate the cushion inboard side shield upward to release the rear pin-type retainer mount from the slot.
3. Hold the cushion inboard side shield in one hand and release the retaining clips holding the safety belt buckle and pretensioner boot to the
cushion inboard side shield.
4. Remove the cushion inboard side shield.
7. Remove the pin-type retainer from the upper seat track mounting flange and install it back into the cushion inboard side shield.
Seats with lumbar
8. NOTE: Make sure the front seat back pad adjuster is in the fully retracted position.
Remove the lumbar control.
1
Remove the 2 screws.
2
Disconnect the cable from the lumbar control.
-
Route out the lumbar cable from under the seat.
