E 250 V8-5.4L (2008)
9. Remove the lumbar actuator.
1. Remove the 2 screws.
2. Disconnect the cable from the lumbar actuator.
-
Route out the lumbar cable from under the seat.
All seats
10. Remove the side shield screw from behind the recliner handle.
11. Remove the cushion outboard side shield rear screw from under the seat.
-
If equipped with manual seat track, remove the cushion outboard side shield.
Seats with power
12. Remove the cushion outboard side shield front screw.
13. Disconnect the seat control switch electrical connector from under the front of the cushion frame and remove the cushion outboard side shield.