E 250 V8-5.4L (2008)
All seats
14. Separate all wire harness pin-type retainers attached to the cushion frame.
15. NOTE:
-
The riser has been removed for clarity.
-
Power seat shown (LH only), manual similar (RH and LH).
-
Two rear seat track-to-cushion frame bolts shown. The 2 front bolts are accessible through the holes in the seat riser.
Remove the 4 seat track-to-cushion frame bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
16. To install, reverse the removal procedure.
Seat Cushion - Rear, Bucket
SEAT CUSHION - REAR, BUCKET
Removal and Installation
All seats
1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.
2. Remove the seat.
-
Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.
