E 250 V8-5.4L (2008)
5. Remove the brake master cylinder.
6. Disconnect the brake booster push rod in the following sequence.
1
Remove the brake booster push rod cotter pin cover.
2
Remove the brake booster push rod cotter pin.
3
Remove the stoplamp switch.
4
Remove the brake booster push rod bushing.
5
Disconnect the brake booster push rod from the brake pedal pin.
7. Remove the 4 brake booster nuts and the brake booster.
^
To install, tighten to 25 Nm (18 lb-ft).
8. To install, reverse the removal procedure.
^
Fill the power steering fluid reservoir.
