E 250 V8-5.4L (2008)
Brake Switch (Cruise Control): Service and Repair
SPEED CONTROL DEACTIVATOR SWITCH
Removal
1. CAUTION:
-
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
-
Make sure the master cylinder reservoir cap is secure before performing this procedure.
-
Do not allow any foreign matter to enter the master cylinder port once the deactivator switch is removed.
Disconnect the battery.
2. Remove the deactivator switch.
-
Disconnect the electrical connector.
Installation
1. CAUTION: Do not allow brake fluid to contact the electrical connector.
Install the deactivator switch.
-
Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
-
Tighten to 18 Nm (13 lb-ft).
-
Connect the electrical connector.
