E 250 V8-5.4L (2008)
5. CAUTION: Do not turn the engine over with the special tool installed or damage to the camshaft sprocket or the bolt can occur.
Install the special tool.
6. NOTE: Slightly loosen the Camshaft Position Aligner tools to allow slight camshaft movement.
Pre-position the camshafts.
1
Rotate the LH camshaft with the Camshaft Alignment Set until the timing mark is approximately at 12 o'clock.
2
Rotate the RH camshaft with the Camshaft Alignment Set until the timing mark is approximately at 11 o'clock.
^
Tighten the Camshaft Position Aligner tools to maintain camshaft pre-positioning.
