E 250 V8-5.4L (2008)
All engines
13. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the CMP sensor and bolt.
^
Tighten to 10 Nm (89 lb-in).
14. Connect the CMP electrical connector.
15. Position the bracket, connect the tubes and install the nut.
^
Tighten to 10 Nm (89 lb-in) for the 4.6L engine.
^
Tighten to 30 Nm (22 lb-ft) for the 5.4L engine.
