Air Bag Arming & Disarming | Instrument Cluster Service | SRS Reset
1
Remove the 2 driver air bag module bolt covers (1 shown).
2
Remove the 2 driver air bag module bolts (1 shown).
3
Disconnect the horn electrical connector.
4
Disconnect the clockspring electrical connector.
5
Remove the driver air bag module.
8. Remove the RH lower instrument finish panel.
9. Remove the RH lower instrument panel reinforcement.
10. Disconnect the passenger air bag module electrical connector.
11. Install the RCM fuse 20 (10A) to the CJB.
12. Connect the battery ground cable.
Reactivation Procedure
