E 250 V8-5.4L (2008)
3. Release the latches and remove the MAF assembly.
4. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
Disconnect the MAF sensor electrical connector.
5. Remove the screws and MAF sensor.
-
To install, tighten to 2 Nm (18 lb-in).
6. NOTE:
-
The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will result in unmetered
air entering the engine.
-
Use the alignment notch to correctly align the inlet side and the outlet side of the engine air cleaner.
To install, reverse the removal procedure.