E 250 V8-5.4L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the wheel speed sensor electrical connector.
3. Disconnect the wheel speed sensor harness clips.
4. Remove the rear wheel speed sensor bolt, spacer and the sensor.
^
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.