E 250 V8-5.4L SOHC VIN L (2004)
11. Remove the fuel charging wiring from the valve cover studs.
12. Disconnect the RH fuel injector connectors.
13. Remove the RH ignition coils.
14. Position the fuel charging wiring in the passenger compartment.
15. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: The bolts are part of the valve cover and cannot be removed.
Remove the RH valve cover.
^
Fully loosen the bolts and remove the valve cover.
^
Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
^
Inspect the valve cover gasket. If the gasket is damaged, remove and discard the gasket. Clean the valve cover gasket groove with soap and
water or a suitable solvent.
