E 250 V8-5.4L SOHC VIN L (2004)
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the driveshaft.
1. Install the driveshaft.
2. Install the bolts.
Extension Housing Gasket
Extension Housing Gasket
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The output shaft and driveshaft are a balanced assembly.
Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.
3. Remove the four bolts.
4. Remove the driveshaft.
