E 250 V8-5.4L SOHC VIN L (2004)
3. Install the transmission fluid cooler tube nuts.
4. Fill the transmission to the specified level with clean automatic transmission fluid.
Transmission Fluid Cooler Tubes- 4R100 Transmission
Transmission Fluid Cooler Tubes- 4R100 Transmission
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If not done previously, carry out the transmission fluid cooler flow test procedure.
3. NOTE: If cooler bypass valve (CBV) assembly removal is necessary, refer to Cooler Bypass Valve-4R100 Transmission.
Remove the fluid cooler tube(s)/hose(s), as necessary.
Installation
1. NOTE: If the CBV assembly was removed, refer to Cooler Bypass Valve-4R100 Transmission for the installation procedure.
Install the fluid cooler tube(s)/hose(s).
